IBM 86655RY - Netfinity 7600 - 8665, Руководство по техническому обслуживанию аппаратной части, Страница: 75 / 294

Installing options
65
• Review the information in “Before you begin” on page 60.
• Read the documentation that comes with the option.
򐂰
1
򍦠 Adapter retention latch
򐂰
2
򍦠 Tab
򐂰
3
򍦠
Adapter retention latch
򐂰
4
򍦠 Adapter
To install a hot-plug PCI adapter:
Attention: Do not remove a hot-plug adapter before performing the operating-
system-defined procedure for disabling the hot-plug PCI slot that
contains the adapter. Failure to do so might cause the system to lock up.
Refer to the operating system documentation.
1. Review the information in “Before you begin” on page 60.
2. Remove the top cover.
3. Determine which expansion slot you will use for the adapter.
Note: You can install hot-plug PCI adapters in PCI slots 3-6 only.
4. Disable the selected PCI slot from the operating system. (Refer to the
documentation that comes with the operating system for information about
disabling a hot-plug PCI slot.) Disabling the PCI slot turns off the power light for
that PCI slot.
Attention: Make sure the power light for the hot-plug PCI slot is off before you
continue with the next step.
5. Remove the expansion-slot cover:
a. Rotate the adapter retention latch counterclockwise.
b. Lift the tab covering the top of the expansion-slot cover and then remove the
expansion-slot cover from the server. Store it in a safe place for future use.
c. Press on the rear latch and lift the rear retainer clip.