IBM 86655RY - Netfinity 7600 - 8665, Руководство по техническому обслуживанию аппаратной части

Страница: 165 / 294

Installing and configuring ServeRAID controllers
155
Attention: The new controller stripe-unit size is set at the factory to 8 KB. If you need
to change this setting, you must change the stripe-unit size before you store data in
the logical drives. After you store data in the logical drives, you cannot change the
stripe-unit size without destroying data in the logical drives. To change the stripe-unit
size, do the following:
1. Click (Create arrays) on the tool bar to switch from Configuration
mode to Information mode.
2. In the Main Tree, click the new controller.
3. Click Actions
Ó
Change stripe-unit size.
4. Click the new stripe-unit size for your installation on the menu.
Using Express configuration: To use Express configuration:
Note: If the Express configuration mode or Custom configuration mode buttons do
not display on the right panel, click (Create arrays) on the tool bar.
1. In the Main Tree, click the ServeRAID controller that you want to configure.
2. If it is not already selected, click the Express configuration radio button.
3. Click Next. The Configuration summary window opens.
4. Review the information that displays in Configuration summary window.