IBM 86655RY - Netfinity 7600 - 8665, Руководство по техническому обслуживанию аппаратной части, Страница: 74 / 294

64
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
򐂰
1
򍦠
Non-hot-plug PCI slots 1-2 (on PCI bus A) (3.3 volt)
򐂰
2
򍦠 Hot-plug PCI slots 3-6 (on PCI bus B)
򐂰
3
򍦠
Power LEDs for hot-plug slots
򐂰
4
򍦠 Internal Attention LEDs for hot-plug slots
򐂰
5
򍦠 External Attention LEDs for hot-plug slots
Adapter considerations
Before you continue with the adapter-installation procedure:
• Review the documentation that comes with the adapter and follow those
instructions in addition to the instructions given in this chapter. If you need to
change the switch or jumper settings on the adapter, follow the instructions that
come with the adapter documentation.
• Slots 3 through 6 support 5.0V, 3.3V, and universal PCI adapters.
Note: Universal PCI adapters support both 3.3 V and 5.0 V operation.
• Slots 1 and 2 support 3.3 V and universal non-hot-swap PCI adapters only.
• The server uses a rotational interrupt technique to configure PCI adapters.
Because of this technique, you can install a variety of PCI adapters that currently
do not support sharing of PCI interrupts.
• The system scans PCI slots 1 through 6 to assign system resources; then the
system starts (boots) the PCI devices in the following order: processor board
devices, slots 1 and 2, and then slots 3 through 6.
• The performance of the PCI adapters depends on the types of adapters in the
system.
Installing a hot-plug adapter
Refer to the following illustration to install a hot-plug PCI adapter.
Note: The illustrations in this book may be slightly different from your server.
Before you begin:
• Read “Safety information” on page 249.