IBM 866011U - Netfinity 5500 - 8660, Руководство по техническому обслуживанию аппаратной части

Страница: 217 / 402

Installing devices in the NetBAY3
This appendix contains information about installing devices
in the NetBAY3.
Note
The illustrations in this appendix do not show the
server on top of the NetBAY3, however, you do not
need to remove the NetBAY3 to install devices.
General considerations:
You can install three
types of devices in the NetBAY3:
Ÿ
Devices, such as the IBM EXP10, that sit on side rails
Ÿ
Cantilevered devices, such as a power distribution
unit (PDU), that are screwed to the front or rear of the
NetBAY3
Ÿ
Devices that sit on the NetBAY3 base plate
Notes
1. To allow the NetBAY3 front bezel to close,
devices with handles must not protrude out more
than 56 cm (2.2 in.). The following illustration of
the front bezel top-view cross section shows the
clearances.
2. All device cables must exit from the rear of the
NetBAY3.
56 mm (2.2 in.)
30 mm (1.2 in.)
Netfinity 5500 - Type 8660
209