The server can also be powered on by the
system management processor.
The server can be deactivated as follows:
You can turn the server off by pressing the
Power Control button on the front of the server.
Pressing the Power Control button starts a
graceful shutdown of the operating system, if this
feature is supported by the operating system,
and places the server in standby mode.
Note
After turning off the server, wait at least 5
seconds before pressing the Power Control
button to power the server on again.
Pressing and holding the Power Control button
for more than 4 seconds causes an immediate
shutdown of the server and places the server in
standby mode. This feature can be used if the
operating system hangs.
Disconnecting the server power cords from the
electrical outlets will shut off all power to the
server.
Note
Wait about 15 seconds after disconnecting
the power cord for the system to stop
running. Watch for the System Power light
on the information LED panel to stop
blinking.
Reset Button: Press this button to reset the system
and run the power-on self-test (POST).
Information LED Panel: The lights on this panel
give status information for the server. See
“Information LED panel” on page 189 for more
information.
Diskette-Eject Button: Press this button to eject a
diskette from the drive.
CD-ROM Eject/Load Button: Press this button to
eject or retract the CD-ROM tray so that you can
insert or remove a CD.
CD-ROM Drive In-Use Light: When this light is lit,
the CD-ROM drive is being accessed.
Diskette Drive In-Use Light: When this light is lit,
the diskette drive is being accessed.
Hard Disk Lights: Each of the six hot-swap drive
bays has a set of two lights, which indicate the
following:
Hard Disk Status Light: When the amber light
for a hard disk drive is lit continuously, the drive
has failed. When the light flashes slowly (one
flash per second), the drive is being rebuilt.
Netfinity 5500 - Type 8660
159
Содержание 866011U - Netfinity 5500 - 8660
