IBM 866011U - Netfinity 5500 - 8660, Руководство по техническому обслуживанию аппаратной части

Страница: 194 / 402

c. Grasp the handle
.5/
on the power supply and
pull the handle toward the center of the server;
then, slide the power supply out of the chassis.
Note
During normal operation, each power-supply
bay should have either a power supply or
filler panel installed for proper cooling.
4. If you are not installing a replacement power supply:
a. Disconnect the power cord for the power supply
that you replaced.
b. Install a power-supply filler panel; then go to step
5.
If you are replacing the power supply:
a. Place the handle
.5/
on the power supply in the
open position, and slide the power supply into
the chassis.
b. Gently close the handle
.5/
on the power supply
to seat the power supply in the bay.
c. Make sure the Power switch
.6/
on the power
supply is in the On position.
d. Verify that the ac Power light
.7/
and dc Power
light
.8/
are lit, indicating that the power supply
is operating correctly.
Caution
When the power-cord strain-relief bracket
option is installed on the power cord, the
server must be plugged to a power source
that is easily accessible.
e. Install a power-cord strain-relief bracket
.1ð/
, if
desired.
5. If you have other options to install or remove, do so
now; otherwise, go to “Completing the installation” on
page 154.
186
Netfinity Server HMM