IBM 315, Руководство пользователя

Страница: 155 / 245

Error Messages
POST Error Message Table
The following table shows error messages that might appear on the
screen during the power-on self-test (POST).
Notes:
1. The actions for some of the messages require you to start the
Configuration/Setup utility program. (For instructions, see
Chapter 2, “Configuring Your Server” on page 15.)
2. If a password prompt appears with a POST message, type the
administrator or power-on password; then, press Enter.
POST Message Description
101
102
103
104
105
106
107
108
109 A failure occurred during testing of the system board and
microprocessor.
Action: Have the system serviced.
110 A memory error occurred during testing of the system board.
Action: Run the diagnostic tests to verify that a problem
exists in the memory-module kits.
See the system memory table in “Standard and Optional
Memory-Module Configurations” on page 69 to see if you can
reconfigure (swap) your system memory. This might aid in
identifying the defective memory module.
If you cannot identify the defective memory module in this
way, have the system serviced.
111
112
113 An input/output (I/O) channel check occurred during testing
of the system board and memory. This failure is generally
caused by an adapter.
Action: Have the system serviced.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove the options. If you can start the system
without the option installed, reinstall each option and
retest. When an option fails, replace it.
If a problem still exists, have the system serviced.
Chapter 4. Solving Problems
141