OWNER MAINTENANCE
6-16
If a belt is loose, adjust it by:
1. Loosen the adusting bolts just enough so
that the components can be moved.
2. Whilst pulling outward on the pry bar or
screw driver, test the belt deflection with
your thumb.
3. After tightening the adjusting bolts, be sure
to recheck the belt tension. Overtightening
drive belts can cause excessive wear and
failure in driven components and belts.
YG190A1-E
ADJUSTING DRIVE BELTS
YG200A1-E
CHECKING ENGINE DRIVE BELTS
1. With the engine turned off, check the belts
for cracks, fraying, or excessive wear. Re-
place the belt if it is in poor condition.
2. With your thumb (with a force approx. 10 kg)
press on each belt midway between the
pulleys. Each belt should deflect no more
than the amount shown in figure.
G190D01HP
G190D03HP
Petrol Engine
Generator
pulley
Idler pulley
Water pump
pulley
COMP.pulley
Auto
tensioner
Crankshaft pulley
Generator pulley
Power steering pulley
Idler pulley
Tension pulley
COMP. pulley
Tension
pulley
Tension pulley
Tension pulley
Crankshaft
pulley
Power
steering
pulley
Diesel
Engine
G180A01A-GAT
CHECKING BRAKE PEDAL
CLEARANCE
95 in. (75 mm)
SSA6180A
You need a helper to check the brake pedal
clearance. With the engine running, have your
helper press down on the brake pedal several
times and then hold it down with a force of about
490 N (50 Kg, 110 lbs). The brake pedal clear-
ance is the distance from the top surface of the
brake pedal to the asphalt sheeting under the
floor mat.
If the brake pedal clearance is not within the
limits specified in the illustration, have it in-
spected by your Hyundai dealer and adjusted
or repaired if necessary.