CONTROLS AND EQUIPMENT
1- 18
B220A01A-EAT
SEAT BELTS (2-Point Static Type)
(Rear Seat Centre) (Not all models)
To Fasten Your Seat Belt
To fasten a 2-point static type belt, insert the
metal tab into the locking buckle. There will be
an audible "click" when the tab locks into the
buckle. Check to make sure the belt is properly
locked and that the belt is not twisted.
HTB225
B210A01A-AAT
To Release the Seat Belt
The seat belt is released by pressing the re-
lease button in the locking buckle.
When it is released, the belt should automati-
cally draw back into the retractor.
If this does not happen, check the belt to be
sure it is not twisted, then try again.
B210A01L-D
ZB090U2-A
Adjusting Your Seat Belt
WARNING:
You should place the lap belt portion as low
as possible and snugly across your hips,
not on your waist. If the lap belt is located
too high on your waist, it may increase the
chance of injury in the event of a collision.
B200A01L-D
movement whilst the belt is being worn. How-
ever, in the event of rapid deceleration or im-
pact, the belt mechanism will automatically lock.
The mechanism will also lock if the seat belt
webbing is withdrawn too quickly when the belt
is being fastened or if attempts are made to
withdraw the webbing whilst the vehicle is not
on level ground. Should the seat belt lock under
these conditions, it will be possible to release
the mechanism by allowing a small amount of
webbing to be retracted and the belt withdrawn
again.
Both arms should not be under or over the
belt. Rather, one should be over and the
other under, as shown in the illustration.
