OWNER MAINTENANCE
6-22
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming screen as shown in the illustration. Turn
on the headlight switch. (Low Beam or High
Beam Position).
1. Adjust headlights so that main axis of light is
parallel to centre line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show the cen-
tre of headlights.
"H"
Horizontal centre line of headlights from
ground :
Low Beam : 35.1 in. (894 mm)
High Beam : 33 in. (839 mm)
"W"
Distance between each headlight centre :
Low Beam : 51.8 in. (1,316 mm)
High Beam : 42.4n. (1,076 mm)
"L"
Distance between the headlights and the
wall that the lights are tested against :
Low Beam : 118.1 in. (3,000 mm)
High Beam : 118.1in. (3,000 mm)
G290B01HP-EAT
Adjustment After Headlight Assembly
Replacement
6. Draw the vertical line (through the centre of
each headlight) and the horizontal line
(through the centre of each headlight) on the
aiming screen.
(1) Horizontal line dimension from ground :
Low Beam : 35.1 in.(894 mm)
High Beam : 33 in. (839 mm)
(2) Distance between each vertical line :
Low Beam : 51.8 in. (1,316 mm)
High Beam : 42.4 in. (1,076 mm)
And then, draw a parallel line at 1.50 in. (38
mm) under the horizontal line in case of adjust-
ing the low beam or at 0.83 in. (21 mm) under
the horizontal line in case of adjusting the high
beam.
7. Adjust each cut-off line of the low beam to
the parallel line with a phillips screwdriver -
VERTICAL AIMING.
8. Adjust each cut-off line of the low beam to
the each vertical line with a phillips screw-
driver - HORIZONTAL AIMING.
G290B02HP-DAG
G290B01HP-DAG
<Low Beam>
<High Beam>
Cut-off line
L
W
H
H
"P"
1.5 in. (38mm)
Vertical
line
0.55 in. (14 mm)
Cut-off line
L
W
H
H
"P"
Vertical
line
1.54 in. (39 mm)
0.83 in.
(21 mm)
Ground line
Ground line
