Figure 3-71
Connecting an Ethernet cable
8GEF
6
4
5
7
6
7
4
5
2
0
1
3
2
3
0
1
0
1
2
3
4
5
6
7
2XG8GE
0
1
0
1
10G
0
1
2
3
4
5
6
7
2XG8GE
0
1
0
1
10G
Secospace USG6000
1
3
5
7
2
4
6
8
XXXXXXXXXXXXXXXXXXXXXXXXXXX
0
1
2
3
4
5
6
7
2XG8GE
Ethernet cable
Ethernet interface
of the peer device
Step 3
Lay out the Ethernet cable along a cabinet and route the cable through the cable hole for the
signal cables at the top (overhead cabling) or bottom (underfloor cabling) of the cabinet.
Step 4
Remove the temporary labels and attach labels (2 cm away from the connectors) at both ends
of the Ethernet cable.
----End
Follow-up Procedure
Verify the following after the installation:
l
The labels at both ends of the cable are correct, clear, neat, and facing the same direction.
l
The cables and connectors are free of any damage or breakage and are connected
properly and reliably.
3.5.7 Installing Optical Transceivers and Connecting Optical
Fibers
This section describes how to install optical transceivers on the SFP or SFP+ ports and
connect them to the ports of the peer device using optical fibers according to the network
plan.
Context
The USG supports both SFP and SFP+ optical modules. The optical modules at both ends are
the same, including the optical fiber type (single-mode or multi-mode), optical fiber connector
type (LC/PC, SC/PC, or FC/PC), and transmission rate. If different optical modules are used
at the two ends, the communication may fail.
HUAWEI USG6000 Series
Hardware Guide
3 Hardware Installation
Issue 08 (2017-06-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
326
