User Manual
U-SYS IAD108 Integrated Access Device
Chapter 2 Installing Hardware
2-8
IAD108E uses a straight-through cable to connect the upper
network device. The connection steps are as follows:
1) Insert one end of the network cable into the uplink interface
(the RJ-45 interface close to the power interface) on the
back panel of IAD108E. Align the strip to the gap on the
interface and insert the RJ-45 connector. If a “click” is
heard, the connector is well plugged.
2) Connect the other end of the network cable to the uplink
network device according to actual situations.
II.
IAD108A/IAD108V
IAD108A/IAD108V provides one channel of ADSL/VDSL uplink,
and the uplink interface is the RJ-45 port beside the power interface.
ADSL/VDSL cable is an ordinary telephone line. The connection
steps are as follows:
1) Insert the RJ-11 connector of the telephone line into the
uplink RJ-45 interface on the IAD108A/IAD108V.
2) Connect the other end of the telephone line to the uplink
Digital Subscriber Line Access Multiplexer (DSLAM)
device.
2.2.4 Connecting the Cable on User Side
There are two kinds of subscriber cables: RJ-11 telephone line
and RJ-45 straight-through cable. They are used to connect different
types of subscriber interfaces. The correlation between the
subscriber interfaces and cables are as follows:
z
POTS port: There are eight POTS ports on the rear panel,
which can be connected with RJ-11 telephone line.
