horsch Terrano 4.3 GX, Руководство по эксплуатации

Страница: 19 / 114

Safety and responsibility | 2
60084498 • 01 • 06/2022 • en 19
Ø
When performing welding work on the machine, disconnect the cables from
electronic components. The ground connection must be as close as possible to
the welding point.
Ø
Before cleaning the machine with high pressure cleaner cover all openings,
which should stay clear of water, steam or cleaning agents for reasons of
safety or operation. Do not aim the water jet directly on electric or electronic
components or bearings. When cleaning with high-pressure cleaning equip-
ment or steam jet always keep a distance of at least 50 cm to machine com-
ponents.
Ø After cleaning, check all hydraulic lines for leaks and loose connections.
Ø
Check for chafing and signs of damage. Remedy any faults immediately!
Ø
Retighten screw connections loosened for care and maintenance work.
Ø
Do not clean new machines with a steam jet of a high pressure cleaner. The
paint takes approx. 3 months to cure and could be damaged before this time.
Ø
Danger of explosion! Do not exceed the specified tire pressure, see Mainten-
ance overview .
NOTE
All other maintenance and repair tasks, which are not described in the operating in-
structions, must only be carried out by an authorized professional workshop or by
an operator who has been trained by HORSCH for this purpose.
2.8 Danger zone
The area indicates the danger zone of the machine:
The danger zone around the machine poses the following hazards:
• Accidental operation of the hydraulics can trigger dangerous movements of the
machine.
• With the drive still running, machine parts may rotate or swing out.
• Hydraulically raised machine parts can lower slowly and unnoticed.