Honeywell Ademco Vista-12D, Инструкция по установке и настройке

Страница: 83 / 112

Menu Mode Programming
5-27
PROMPT VALID ENTRIES EXPLANATION
P A R T I T I O N
X
Partition
0 = all partitions
1 = partition 1
2 = partition 2
3 = common partition
[
∗
] to continue
This prompt appears if events “3-8,10” were
selected. Otherwise it is skipped.
Press [*] to continue to the “Start” prompt.
S T A R T S M T W T F S
H H M M A M
0 0 1 0 0 0 0
Start Time
01-12 (00-23)
†
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place “1” under days
[
∗
] to continue
Enter the event’s start time and days of the week
to occur.
To select days, position the cursor under the
desired days using the [
∗
] key to move forward,
then press “1” to select the day(s).
† use 00-23 if 24-hour time is enabled.
W A R N I N G D L Y T I M E
0 0
Warning Delay Time
01-15 = arm warning delay time
in minutes
[
∗
] to continue
This prompt appears if events “4 or 5” were
selected.
Enter the desired amount of time the system
should warn of impending arming. The system
will beep once every 30 seconds to alert users
that arming will soon occur. Otherwise, this
prompt is skipped.
S T O P S M T W T F S
H H M M A M
0 0 1 0 0 0 0
Stop Time
01-12 (00-23)
†
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place “1” under days
[
∗
] to continue
Enter the event’s stop time and days of the
week to occur.
To select days, position the cursor under the
desired days using the [
∗
] key to move forward,
then press “1” to select the day(s).
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (child-not-home report)
† use 00-23 if 24-hour time is enabled.
R E P E A T O P T I O N
0 - 4 X
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly
(every other week)
3 = repeat schedule every third
week
4 = repeat schedule every fourth
week
[
∗
] to continue
Enter the desired repeat option for this
schedule.
e.g., To make a schedule that happens everyday
you would select all days with a repeat count of
1. To make a schedule that runs for one week
then stops, select everyday with a repeat count
of 0.