Honeywell Ademco Vista-12D, Инструкция по установке и настройке

Страница: 65 / 112

Menu Mode Programming
5-9
PROMPT VALID ENTRIES EXPLANATION
10 INPUT S/N: L
A X X X - X X X –
Serial number
S/N = serial number
L = loop number
[
∗
] to continue
Manually enter the serial number (found on the
transmitter label), by typing digits in the “X”
locations, using the [A] (advance) or [B] (back)
keys as required. You can also perform two open
and close sequences; for button-type transmitters
that means pressing and releasing the button
twice.
NOTE : If you want to copy the previous zone’s
serial number, press the [C] key.
Press [
∗
] to advance to the loop number, then
enter loop number.
Press [
∗
] to accept the existing serial and loop
number and continue to the “Confirm” prompt
below. If necessary, press [#] to back up and re-
enter or edit the serial number.
10 INPUT S/N: L
A 0 0 0 - 0 0 0 0 0
To Delete a Serial
Number
[
∗
] to continue
To delete an existing serial number, enter 0 in
the loop number field. The serial number will
change to all 0's as shown.
If
0 was entered in error, simply re-enter the loop
number, and the serial number will return to the
display.
10 XMIT TO CONFIRM
PRESS
✱
TO SKIP
Confirm
[
∗
] to continue
The prompt to confirm appears. This prompt will
only appear if the first prompt after entering
∗
58
was answered “Yes.” To confirm, activate the loop
input or button that corresponds to this zone.
The system checks for a duplicate. If a duplicate
exists, a long error beep will sound.
Press [#] to back up and re-enter the serial and/or
loop number.
Entd A022-4063
Rcvd A022-4064
If Serial or Loop
Numbers do not match
after activating the
transmitter
[
∗
] to continue
If the serial/loop number combination transmitted
does not match the serial and loop number
entered, a display similar to the one below will
appear.
If the loop number does not match, it
will also be displayed. If so, activate the
transmitter’s loop input or button one or more
times.
If a match is still not obtained (i.e., summary
display does not appear), press the [#] key twice
and enter the correct loop input or, if correct,
press [#] again and then enter the correct serial
number.