www.honeybeecnc.com
49
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
switch do not
trigger, the airflow
also keeps the
state of on-off
cycle, AC
indicator twinkle,
air indicator is on,
DC indicator is off
16
Can not cut, the
cutting torch can
ignite arc, has air
flow and fan is
running. AC, air
and DC indicators
are on, but the
temperature
indicator is off
1. Working cable and work piece has not connected well
. Make sure
the working cable connected well and connected to dry and clear place of
work piece.
2. Cutting torch trouble.
The device has to return to the authorized
Service Center.
3. Built in Components have troubles
. The device has to return to the
authorized Service Center.
17
Cutting torch can
cut, but not deep
enough.
1. Wrong input current control setting. Check and adjust it.
2. Cutting torch consumable is worn, check and replace it.
3. Connection between working cable and work piece is bad. Make sure
the working cable connected well and connected to dry and clear place of
work piece.
4. The cutting speed is too rapidly. Slow it.
5. Cutting torch on the work piece is dragged(
The gas saver of cutting
nozzle
return road triggered).The power supply will automatically reduce
the 40A if the cutting nozzle touched work piece when the setting
parameter of output current is more than 40A. The cutting torch must be
moved out the work piece.
6. There are too much the oil and humidity inside cutting torch. The switch
RUN/ Rapid Auto Restart/SET keeps on the state of SET
，
and holding
the cutting torch at the 1/8 inch
（
3mm
）
of the tidy side. Watching the oil
and humidity when operator cleans them, but pay attention not to trigger
the cutting torch. The air need to filter again if there is the pollution.
7. The input powers supply have the problem of the fluctuation. Let the
electrician check the voltage of input cable.
8. Components inside device has trouble.Return to the authorized Service
Center.
18
The arc off during
running, no arc
after trigger torch
switch again.
1.The power supply is too hot.(Temperature indicator is on). Cool the
device down at least 5 minutes.
2.The fan blade is blocked.(Temperature indicator is on) Check and clean
it.
3. The airflow is blocked.(Temperature indicator is on). Check the blocked
airflow around the machine and change the blocked condition.
4. Air pressure is too low.(Air indicator is not on when the cutting torch
