www.honeybeecnc.com
42
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
Chapter 9 Maintenance & Troubleshooting
9.1 Daily Maintenance
1
．
Clear the rack and rail.
2
．
Turn off power supply and all gas resources after off duty.
9.2 Weekly Maintenance
1
．
Check if torch loose.
2
．
Please clear the whole machine carefully and lubricate necessary places.
9.3 Monthly Maintenance
1
．
Please be sure the air inlet port is dust-free, and all the valves and motors work normally
。
2
．
Please replace the gas pipe if it was broken.
3
．
Make sure that all the gas pipes connector is firmly installed, and there is no crack of pipes. Fix or
replace as necessary.
4
．
Make sure that all screws on working platform firmly installed and dust-free.
。
5
．
Please make sure that all the buttons and switches are in good state. Replace them if necessary.
。
6
．
Please check all sockets of the Black panel, Please contact with us if you need to replace it as soon
as possible.
7
．
Please keep all the power cables in good state.
9.4 Trouble Shooting
Question: How to operate the control and error compensation in automatic cutting?
Answer
: Only the following operative keys can be used after the automatic cutting started.
1
．【
PAUSE
】
key
：
The system will stop by pressing STOP (the RED button on front panel). The system
will still be in the current menu and it will continue working by pressing START key (GREEN button on
front panel).
If there is cutting error, please press Y+, Y-, X+, X- keys to adjust torch position. The torch moving is
regarded as compensation. When the torch is located at required position, please press START key to
keep on cutting.
2
．
[ F
↑
] [ F
↓
] used for speed up/ down, each by 1%.
3
．【
Pgup/s
↑
】、【
Pgdw/s
↓
】
used for torch UP/DOWN while user pressing those keys.
Q: The solution for which the plate has not been penetrated?
A:
The function of back to the original track may be used to solve it when the operator meets this
problems. The following is the detailed operation.
To press
【
PAUSE
】
key
，
Make the system stop slowly, the system show PAUSE ,then Press
【
F5
】
entry
into the Back and cut function. Please press the
【
START
】
to cut during the Back function if the it arrived
at the position you want.
Q: How to do if the power suddenly off during cutting or man-made cut stop? Can the un-finished
program continue to cut?
A
：
Yes, the operator can use Breakpoint function
when you meet above situation. The following is
the detailed operations:
