www.honeybeecnc.com
27
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
5.6.2 Cutting position adjustment after pause.
Torch position need to be adjusted if under following situations:
1) Burning torch blocked, or need to be changed, move torch to safe position, return to the starting point
after treat well;
2) Need pierce externally, don’t want pierce outside workpiece. Find a suitable position, (usually steel
plate edge), cut along direct line until start point (without pause) and continue normal process after
pierce.
3) Transfer cutting, lots of workpieces, wide cutting size, need change cutting place.
The following several operations can adjust cutting position:
(1)Pause, (2)Back, (3)Pierce, (4)Select paragraph and process, (5)choose hole and processing,
(6)Breakpoint back
Under the above conditions, if want to change torch position, can directly press
【
↑
】【
↓
】【
←
】【
→
】
to
adjust (now the system is under manual rate, can be adjusted). After adjust to ideal place, press
【
start
】
button, dialog appear as follows:
Pic.26 Position adjustment options
5.7 ORI PATH RET(original path return)
When it is necessary to return the cutting torch along the original path due to failure to cut through in
machining operation, handle it in the following ways:
Press
【
pause
】
key, make the running system slow down, system shows the" pause "mark, and indicate
as below picture.
Pic.27 Processing
1) ORI PATH RET(original path return)
Return the cutting torch to the adjustment beginning point at speed G00 and wait for other operation; at
this step, it is allowed to press an heavy-current function key such as IGN(ignition), PREHEA(piercing
preheat), CUT(cutting oxygen), etc. Tip: The system will continue to process from the breakpoint location
if [PIERCE] key is pressed after preheating.
2) CUT RET(cut return)
