www.honeybeecnc.com
22
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
The bottom indicators show the status of 8 output ports,
○
indicating no signal output and
●
indicating
signal output.
5.3.5 Machining Parameters Indication
This zone indicates various parameter values in the current machining mode.
5.3.6 Selection of Coordinate Unit
The coordinates may be indicated in
Metric
(millimeter) or
English
system(inch) , depending on the
Metric/English Selection in SETUP(Refer to Parameter Control).
5.3.7
【
1
】
Zoom Out
The shape will be magnified one times by one keystroke and it can be magnified to eight times maximum
by three keystrokes.
5.3.8
【
2
】
Resist
To restore to normal shape size.
5.3.9
【
X
】
Test
If [X] key is pressed, the system will run the program at top speed without executing
Ｍ
command. This
feature is often used to position quickly or check the working size of steel plate. This operation can be
paused at any moment or cancelled by pressing [X] key one more times.
5.3.10
【
Y
】
Running/Machining Speed
Since the manual speed and automatic speed is separate in the system, this key is used to switched
between automatic mode and manual mode to adjust the speed multiplying factor.
5.4 Function selection in AUTO mode
It is allowed to invoke a machining program by function of EDIT . If a program has been invoked (as long
as it is the same program name), it can be run directly.
If the program is invoked from an USB disk, especially a large program, it can be run directly with USB
disk connected instead of saving it into the system.
5.4.1
【
F1
】
SECTION
To assign system to start up machining operation from any section or piercing point.
It is often used when machining needs to start from a certain section or only a part needs being
processed. Refer to
SECTION
feature for details.
5.4.2
【
F2
】
MAN
To switch the system to manual mode.
5.4.3
【
F3
】
RESBREK
After this function is selected, pressing [
START
] key to fulfill breakpoint restoration. Refer to
RESBREK
feature for details.
5.4.4
【
F4
】
VIEW
It is used to test the program for any error. When this feature is selected, the shape of machining
program will be displayed with a cross cursor at the origin.
[S] key is used to magnify the pattern, one times by one keystroke and eight times maximum by three
keystrokes. [Q] key is used to return the pattern to original size. The display position of pattern is
moveable by pressing [
↑
], [
↓
], [
←
] and/or [
→
] key.
