www.honeybeecnc.com
43
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
1.
If there is man-made cut stop, the current working path will be saved in the system, no matter user
restarts machine or not. When user restarts the machine or in auto mode, if there is no change of
current program, the system will carry out breakpoint recover function by pressing
【
F1
】
(AUTO)----
【
F5
】
(BREAKPOINT). After find the breakpoint , the system will remind,
then to start ignition,
pressing START key to start cutting from breakpoint.
2.
If you have quit AUTO machining after machine pause, and enter manual mode (no matter how
much), press [G], the torch will automatically locate at breakpoint, then carry breakpoint recovery
function . But if the coordinate values has been modified in manual mode, the function is not
available.
3.
If there is accidently power off, after poweron, select Automatic mode firstly, then choose
BREAKPOINT function, set the current coordinate values as BREAKPOINT, then to carry out above
function and recover breakpoint.
Note:
Never move the torch after power off!
Q: Why some cutting machine can’t read the CNC (or MPG) file copied from the Windows Explorer
directly?
A:
A few cutting machine doesn’t support explanatory note, the CNC files (the former version is MPG)
include the explanatory note and may send to Disk or Folder, then can also change CNC programming
into the CNC code . The cutting machine supported for note can not only copy in the Windows Explorer
but also send to the Disk or Folder by emulation.
Q: why does
the dead machine
usually happens when the programs is transferred by U Stick?
A
：
If the U disk quality is good, there are maybe two reasons:
1. There are a few of files in U stick which can’t read by system or include the wrong programming. The
system will read the files again and again by using the function of
【
DOWNLOAD
】
, so the dead machine
usually happens.
Suggestion
：
there is only the files you need inside U stick during downloading the documents. The other
documents can be cut and save in other space.
2. Please check out the USB socket and the circuit board may loosen, and look at if there are too much
dust.
If need remove the machines case during trouble shooting, please ask professional electrical to
deal with.
9.5 CNC Controller Troubleshooting
Fault Symptoms Fault Check
Fault Analysis
Recommended Solutions
Suddenly
breakdown in
normal operation
Always stop at the same
position in every operation
cycle
a. Machining program at fault
b. CNC software at fault
Dispatch the software back to the
manufacturer for professional
troubleshooting.
The system still runs but the
cutting torch stops abnormally
along all axes or one axis.
a The travel motor is locked.
b The travel motor fails.
Check if the machine is frozen and level
enough.
