www.honeybeecnc.com
35
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
F
To designate machining speed for G01, G02 and G03
Note 1:
The following rules are valid in the definitions below:
X[U]n--- It is allowed to be either X or U, n stand for a value, but only one appears;
Y[V]n----It is allowed to be either Y or V, n stand for a value, but only one appears;
PPn----It is allowed to be a combination of any two axes or one axis at least.
Note 2:
In command execution, the previous program has higher priority than the following one; for the
same program, M S and T command have higher priority than G command.,
6.2.2 Coordinate System
This CNC system uses standard rectangular coordinate system, as shown in the picture below.
Pic. 38 Rectangular coordinate system
6.3 M Auxiliary Commands
Main Commands of this machine:
M00
Program suspension command.
The program execution will be suspended at this command
until
【
START
】
key is pressed.
M02
Program end
command
. The program will be pended at this command.
M07
Fixed loop of piercing
(M07 allows to relocate the cutting torch, but impossible to return)
M08
Fixed loop of cutting stop.
+X
+Y
O
