www.honeybeecnc.com
26
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
These two speed multiplying factors are permanently saved and subject to no affect from
power-off operation once they are set.
5.5.2Start Automatic Mode
Before starting automatic mode, select correct machining program and appropriate machining
speed(multiplying factor). Move the cutting torch to the cutting position. After the other preparation ok,
press the Green key
【
START
】
to start automatic mode.
5.6 Control and adjustment of cutting position in automatic mode
5.6.1 Only the following keys are enabled when the system starts automatic mode:
【
PAUSE
】
: If this key is pressed, the system will slow down and stop movement, shut off cutting
oxygen(shut off arc switch in plasma cutting mode), remain the current display still.
Pic.25 Pause Display
After the system operation is paused, it is allowed to perform the following operations:
(a)Choose new pierce point, press
【
F5
】
key, input new pierce point number, system will go to the new
pierce point and wait for pierce operation;
(b)Return along the original path;
(c)adjust position;
(d)exit machining operation;
(e)
【
START
】
: restore system operation;
(f) Press
【
ESC
】
key to exit the machining program and return to automatic mode window.
(g)
【
F
↑
】，【
F
↓
】
Movement speed adjustment key: increase or decrease the rate of speed
If equip Motorized Torch Lifter,
【Ｓ
↑
】
,
【Ｓ
↓
】
control torch up and down.
