www.honeybeecnc.com
37
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
Some parameters is invalid, please keep ex factory setting and do not set.
If don’t know the parameter application, please be careful.
Some parameter setting is not application for this machine, please don’t set.
7.1Speed Parameters
In the sub-menu of the SETUP parameters, press
【
F1
】
key and enter SPEED parameter setting
interface, as picture 40:
Pic. 40 Speed Parameters Setting
Speed parameters include--
Starting speed
----The starting and stop speed of system in X axis and Y axis in mm/min or inch/min.
(Note: Metric system/ British system)
Adjustment time
----The time required for the system to accelerate from starting speed to maximum
speed limit, in seconds.
Uniform acceleration time
---- In the process of acceleration/deceleration, the time needed for linear
acceleration, which is usually little bit smaller than the adjustment time by one tenth approximately.
Maximum speed limit-
---The top speed of running system in manual control mode and in execution of
G00 command, in mm/min. or inch/min.
Machining speed limit
-----The top machining speed in flame/plasma machining operation, in mm/min.
or inch/min.
Return to mechanical original point speed----
The machine reset speed, in mm/min. or inch/min.
Backward/forward speed
-----The system backward speed, in mm/min. or inch/min.
Conversion angle of corner speed
----- When the running direction changes between program
segments and changing angle exceeds this angle, the system will decelerate to the starting speed
around the corner. This value is normally set smaller when the system is comparatively heavier. In
addition, such considerations as machining speed and machine vibration should be taken as well,
smaller value for worse vibration.
