www.honeybeecnc.com
29
Dalian
Honeybee
CNC
Equipment
Co.,Ltd.
Tel:
+86
411
85865100
Fax:+86
411
85866100
CUT RET:
little bit off from the breakpoint after breakpoint restoration, whic is somewhat like piercing
along the exterior margin, making the breakpoint more smooth;
HOLE HERE:
the same operation as previous, which can also be used for transitional cutting.
Now, it is allowed to press a heavy-current function key such as IGN(ignition), PREHEA(piercing preheat),
CUT(cutting oxygen), etc.
Tip: The system will continue to process from the breakpoint location if [PIERCE] key is pressed after
preheating.
If press
[ESC]
key when a breakpoint is found, the system will exit machining mode.
Attention: Never try to change the machining program, rotation angle and scaling proportion
whether it is breakpoint restoration or power-off restoration, which will be automatically saved
by the system and free from affect by power-off operation; otherwise, the system can not find the
breakpoint.
5.9 SECTION(section selection)
5.9.1 Start SECTION function
SECTION: to assign system to start up machining operation from any section or piercing point.
Press
【
F1
】
to select SECTION function and the system will show a menu as shown in the picture below:
Move the cursor with
【
↑
】
or
【
↓
】
key and make one choice from two machining options.
According to your option, the system will prompt to input the serial number of the option(program line
number or the serial number of piercing point).
5.9.2 Two cases for SECTION machining option:
(1) Transitional machining: to start machining somewhere different from the start position of the program;
(2) Repeat the machining opearation starting from a certain section of the program.
For the former case, a scrap work piece is often used for aiming at the piercing point and machining
directly(
HERE POSITION
option);
For the latter case, the reference point is used for positioning(
REF POSITION
option).
For these two options, the system will prompt an option menu as shown below after startup:
Pic.30
Option
dialog
box
prompted
by
the
system
after
machining
start
if
SECTION
machining
Pic.29 SECTION function menu
