HNC Electric HV480 Series, Руководство пользователя

Страница: 85 / 179

81
K4 K3 K2 K1 Command setting Corresponding
parameter
OFF ON OFF ON
Multi - segment
instruction 5
FC-05
OFF ON ON OFF
Multi - segment
instruction 6
FC-06
OFF ON ON ON
Multi - segment
instruction 7
FC-07
ON OFF OFF OFF
Multi - segment
instruction 8
FC-08
ON OFF OFF ON
Multi - segment
instruction 9
FC-09
ON OFF ON OFF
Multi - segment
instruction 10
FC-10
ON OFF ON ON
Multi - segment
instruction 11
FC-11
ON ON OFF OFF
Multi - segment
instruction 12
FC-12
ON ON OFF ON
Multi - segment
instruction 13
FC-13
ON ON ON OFF
Multi - segment
instruction 14
FC-14
ON ON ON ON
Multi - segment
instruction 15
FC-15
When the frequency source is selected as multi-segment speed, 100.0 % of the function codes FC - 00 ~ FC -
15 correspond to the maximum frequency F0 - 16. In addition to being a multi-stage speed function, multi-stage
instructions can also be used as a given source of PID or as a voltage source for VF separation control, etc. to meet
the need of switching between different given values.
Table 2 description of terminal function for acceleration and deceleration time selection
Terminal 2 Terminal 1
Selection of acceleration or
deceleration time
Corresponding parameter
OFF OFF Acceleration time 1 F0-10, F0-11
OFF ON Acceleration time 2 F6-17,F6-18
ON OFF Acceleration time 3 F6-19,F6-20
ON ON Acceleration time 4 F6-21,F6-22
Attached table 3 motor selection terminal function description
Terminal 2 Terminal 1 Motor selection
OFF OFF Motor 1
OFF ON Motor 2
F5 - 10 X input terminal filtering time 0.000s
～
1.000s [0.010s]
Set software filtering time for X terminal status. If the input terminal is easily interfered and causes misoperation in
use, this parameter can be increased to enhance the anti-interference ability.
However, the increase in the filtering time will cause the response of the X terminal to slow down.