HNC Electric HV480 Series, Руководство пользователя

Страница: 126 / 179

122
U0-08 Do output state Indication range 0
～
1023
Display the current DO terminal output status value. After being converted into binary data, each bit corresponds
to a DO signal, indicating the output high level for 1 and the output low level for 0. The correspondence between
each bit and the output terminal is as follows:
Bit1 Bit3
Relay 1 DO1
Bit4
DO2
U0-10 AI2 voltage ( v ) / current ( mA ) Indication range
0.00V
～
10.57V
0.00mA
～
20.00mA
U0-14 Load speed display Indication range 0
～
65535
U0-15 PID setting Indication range 0
～
65535
U0-16 PID feedback Indication range 0
～
65535
Display the PID setting value and feedback value. The value format is as follows:
PID setting = PID setting (percentage) * FA - 04
PID feedback = PID feedback (percentage) * FA - 04.
U0-18 PULSE input pulse frequency Indication range 0.00kHz
～
100.00KHz
Display X5 high speed pulse sampling frequency, minimum unit is 0.01 KHz.
U0-19 Feedback speed Indication range -320.00Hz
～
320.00Hz
U0-20 Remaining operating time Indication range 0.0
～
6500.0 minutes
U0-21 AI1 pre-correction voltage Indication range 0.000V
～
10.570V
U0-22
AI2 voltage / current before
correction
Indication range
0.000V
～
10.570V
0.000mA
～
20.000mA
U0-23 AI3 voltage before correction Indication range -10.570V
～
10.570V
Display the actual value of the analog input sample voltage / current.
The voltage / current actually used has been linearly corrected so that the sampled voltage / current is in line with the
actual input voltage / electricityThe flow deviation is smaller.
See U0 - 09, U0 - 10, U0 - 11 for the correction voltage / current actually used, and P3 group for the correction
method.