Hitachi L100 IP Series, Инструкция по эксплуатации

Страница: 75 / 94

Chapter 13 – The optional remote operators
13-1
Chapter 13 – The optional remote operators
Connection of the remote operator
Remote operator is intended for easier configuring or copying parameters prior to normal use of the inverter,
not for daily operation combined with L100IP because remote operators are not IP54 version, and the
modular jack don’t go through the glands.
Before the optional remote operators DOP, DRW, or OPE-J can be connected the power supply to the
inverter has to be switched off. Then the cable must be plugged into the inverter as shown in the figure. Now
the power supply can be switched on again. The inverter is now in monitor mode and on the remote
operator’s LCD display the message
FS000.0... is shown.
DOP, DRW
OPE-J
The parameters that have been configured using L100IP series inverters can now be copied to other inverters
using the copy unit DRW-0A2. The old model DRW-0A can not be used for this purpose.
When inverters are operated with a remote operator connected, the following items must be noted:
-
The remote operator’s cable must not be attached or removed during operation (i.e. if the power supply to
the inverter is switched on).
- The digital operator of the inverter can not be used while the remote operators DOP or DRW are being
connected.
- All remote operator keys are inactive except the STOP/RESET key while the remote operator OPE-J is
being connected (also refer to the description of function
b 89 in chapter 8 under “Extended functions of
group B”).
Set the dip switches on the back of the remote operator as follows:
OFF
ON
1 4
Setting for L100 and J300:
Position 1: OFF
Position 2: ON
2 3
Not used
When ON, the copy unit cannot be
read out. When the READ key is
pressed, the message RD LOCK
will be displayed