Hague Watermax 10 Series, Руководство пользователя

Страница: 7 / 40

10 Series Owner’s Manual
5
12. Fill the brine tank with salt.* Note: Do not mix pellet with solar salt!
13. Open the inlet valve and turn on the electricity to the water heater. To
complete the installation, open a cold water tap and allow the appliance
to flush for 20 minutes or until approximately 72 gallons have passed
through the appliance. Verify flashing light on controller, indicating
water flow. (See Figure 2, below.)
14. Make sure the bypass valve is left in the “service” position. Test the
water at the test port to verify soft water.
15. Place covers on both cabinets.
*When using potassium chloride as an alternative to sodium chloride,
increase the hardness setting by 12%. Note: we do not recommend using
potassium chloride when iron is present in the raw water supply.
SETTING & USING THE SYSTEMS CONTROL
Control Panel Buttons
(A) SERVICE SETTINGS
This section is recommended for qualified service personnel only. Must be
set correctly for proper performance.
FUNCTION: Used to enter SERVICE SETTINGS mode. All three
OPERATING MODES can be selected and all operating parameters can be
set for each OPERATING MODE when this button is activated.
A
B
C
D
E
Figure 2
F
G