Hague Watermax 10 Series, Руководство пользователя

Страница: 6 / 40

10 Series Owner’s Manual
INSTALLATION AND START UP
1. Place the 10 Series in the desired location. Turn off the electricity and/or
water supply to the water heater. Make sure the inlet, outlet and drain
connections meet the applicable local codes. Check arrows on the bypass
valve to be sure the water flows in proper direction.
CAUTION: Do not
plumb the appliance in backwards.
2. The drain hose must be a minimum of 1/2" I.D. tubing and should make
the shortest run to a suitable drain.
3. Connect the salt tank to the valve head with the flexible 3/8" plastic tube
included with the system. Be sure to insert the plastic insert in the end of
the brine tube. (See Figure 13, page 32.)
Connect the Overflow Line to the brine tank. If the brine tank is filled
with too much water, or if there is a malfunction, an overflow line will
direct excess water to drain.
Insert the 2 pc. Overflow fitting into the outside of the cabinet and attach
it with the plastic thumb nut. Connect ½" I.D. tubing (not supplied)
between the overflow fitting and a suitable waste receptor. Maintain a
minimum of 2" (50 mm) air gap between the drain line and the flood
level rim of the waste receptor to prevent back siphoning. This is a
gravity drain. The overflow line must end at a drain that is at least 3"
lower than the bottom of the overflow fitting.
4. Attach the drain line. Route the drain line to a floor drain, laundry tub or
other suitable waste receptor. Maintain a minimum of 2" (50 mm) air
gap between the drain line and the flood level rim of the waste receptor
to prevent back siphoning.
5. Place the appliance in the bypass position and turn on the main water
supply. Open the nearest cold water faucet to flush the plumbing of any
excess soldering flux, air, or any other foreign material.
6. Close the faucet and check for leaks. If leaks are found, turn off the main
water supply and open the nearest cold water faucet to depressurize the
lines. Close the faucet to eliminate siphoning action. Repair leaks.
Place the bypass in the “service” position. Slowly open the main water
supply valve and fill the WaterMax. Then open the nearest cold water
faucet to purge air out of the appliance. Close faucet.
7. Connect transformer power cord to the back of the controller.
8. Plug in transformer.
9. Program the Systems Control as outlined on Page 5-11.
10. Add water to the brine tank. Fill to a minimum of 2" above the grid
plate. Make sure that the salt dosage is set as recommended for the
application. After the first regeneration, the appliance will automatically
refill the correct amount of water into the brine tank.
11. Initiate a manual regeneration and inspect for proper operation. Allow
the appliance to draw all the water out of the brine cabinet until the air
check sets. Then advance to Brine Refill position by using Change &
Select buttons simultaneously. Let the tank fill with proper amount of
water. The controller will then step the valve to the Home position.