Hague Watermax 10 Series, Руководство пользователя

Страница: 24 / 40

10 Series Owner’s Manual
93223 Injector Throat : In conjunction with the Injector Nozzle, Part # 93221, it creates the vacuum
that draws the brine solution from the brine cabinet. The center hole should be clear of debris, round and
undamaged. The Throat should be pressed flush into the opening in the valve. If the Throat is removed, it must be
replaced with a new one.
93220 Thick Injector Seal : Seals between the Injector Nozzle and the Main Valve Body. The gasket has a
definite hole pattern that has to match-up with the Nozzle and Main Valve Body opening. The
gasket seals at its outer edges and between the inlet screen and nozzle opening. These areas must be
free of defects such as tears or pits and be free of debris.
93221 Injector Nozzle : Together with the Throat, 93223, creates the vacuum that draws the brine solution from
the Brine Cabinet. There are two openings in the Nozzle plate. The small hole, flush on
both sides, is the one that creates the “injection-stream” that enters the Throat. It is very important that
this hole is clear of debris, round and undamaged. If this hole becomes “clogged”, do not use anything
to clear this opening that could damage it, such as metal objects. Use a clean cloth and flush with
water. If necessary, a wood toothpick may be used. When assembling to the Valve, the Nozzle hole
should line up with the Throat.
93232 Thin Injector Seal : Seals between the Injector Nozzle and Injector Cap. The gasket must be free
of defects such as tears or cuts and be free of debris.
93222 Injector Cap : Holds the injector assembly together and seals the assembly to the Main Valve
Body. The four machine screws should be tightened evenly and “snug”.
93810 Injector Screen : Acts as pre-filter to keep debris from entering the Injector Nozzle and Throat.
Attaches to the cylinder on the Nozzle plate and spherical “bump” inside the Valve Body. Some
Compression of the Screen may occur during assembly. The opening in the screen must be clear to insure
Proper flow to the Injector assembly.