Hague Watermax 10 Series, Руководство пользователя

Страница: 32 / 40

10 Series Owner’s Manual
PARTS --- DRAIN END CAP ASSEMBLY
(1) 90268 Drain End Cap: Seals the left opening on the Main Valve Body. The opening is sealed with an O-ring
used as axial or “face” seal. The O-ring sits in a groove in the End Cap. This groove must be free of defects such as
pits or scratches and also free of debris. When assembling the End Cap to the Valve Body, care should be taken to
make sure that the O-ring stays in the groove in the End Cap. If misaligned, the O-ring can become pinched and
leak.
(2) H2086 Drain Line Flow Control Button: The Drain Line Flow Control Button (D.L.F.C.) maintains a constant
(plus or minus 10%) backwash flow rate at varying pressures. Care should be taken when replacing FCB’s to insure
that the correct rate is being used for a particular model. Refer to Engineering Specifications, pg. 12. The flow
control button should be assembled with the lettering facing the retainer.
H2086 – 2.4*
H2086 – 3.0*
H2086 – 5.0*
H2086 – 7.0*
(3) 90267 Retainer: The Retainer holds the backwash Flow Control Button in place. One side is smooth and the
other has a groove for a screw driver. When assembling the retainer to the Drain End Cap, the retainer should be
“screwed” in until it stops. If the retainer is not fully engaged, the Flow Control may not function properly.
(4) 93808 End Cap O-ring
90614 Drain End Cap Assembly (contains all of the above items)
* The numbers shown after the Drain Line Flow Control Button Part # indicate the back wash flow rate in
gpm.
Figure 11