H3C S5120-EI Series, Руководство по эксплуатации

Страница: 782 / 1191

1-15
Activating an RRPP Domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable RRPP
rrpp enable
Required
Disabled by default
Enter RRPP domain view
rrpp domain domain-id
—
Enable the specified RRPP ring
ring ring-id enable
Required
Disabled by default
To prevent Hello packets of subrings from being looped on the primary ring, enable the primary ring on
its master node before enabling the subrings on their separate master nodes. On an edge node or
assistant-edge node, enable/disable the primary ring and subrings separately as follows:
z
Enable the primary ring of an RRPP domain before enabling the subrings of the RRPP domain.
z
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
Configuring RRPP Timers
Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Configure the Hello timer and
Fail timer for the RRPP domain
timer hello-timer hello-value
fail-timer fail-value
Required
By default, the Hello timer value
is 1 second and the Fail timer
value is 3 seconds.