H3C S5120-EI Series, Руководство по эксплуатации

Страница: 1173 / 1191

1-11
the front panel is numbered 0, and subslots of the two expansion slots on the rear panel are
numbered 1 and 2 from left to right.
z
Interface serial number is dependent on the number of interfaces supported by the device. View
the silkscreen on the interface card for the number of supported interfaces.
For example, GigabitEthernet 1/0/1 is an interface on the independently operating device
Sysname
. To
set the link type of GigabitEthernet 1/0/1 to trunk, perform the following steps:
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
For an IRF member, the interface name also adopts the previously introduced format: member ID/slot
number/interface serial number, where
z
The member ID identifies the IRF member on which the interface resides
z
Meaning and value of the subslot number and the interface serial number are the same as those on
an independently operating device.
For example, Ethernet 1/0/1 is an interface on IRF member slave 3 (member ID is 3). To set the link type
of GigabitEthernet 1/0/1 to trunk, perform the following steps:
<Master> system-view
[Master] interface gigabitethernet 3/0/1
[Master-GigabitEthernet3/0/1] port link-type trunk
File system name
You can use the name of the storage device to access the file system of an independently operating
device. For the naming rules of a storage device, refer to the
File System Management Configuration
in
the
System Volume
.
For example, flash is the storage device on the independently operating device Sysname. To back up
the file
aa.cfg
under the root directory of the flash to the
test
folder, perform the following steps:
<Sysname> mkdir test
...
%Created dir flash:/test.
<Sysname>copy aa.cfg test/aa(20080714).cfg
Copy flash:/aa.cfg to flash:/test/aa(20080714).cfg?[Y/N]:y
..
%Copy file flash:/aa.cfg to flash:/test/aa(20080714).cfg...Done.
<Sysname> cd test
<Sysname> dir
Directory of flash:/test/
0 -rw- 1568 Jul 14 2008 11:54:04 aa(20080714).cfg
30861 KB total (20956 KB free)
To access the file system of the master, use the name of the storage device; to access the file system of
a slave, use the name in the following format: Member-ID#Storage-device-name.
For example:
1) To access the
test
folder under the root directory of the flash on the master, perform the following
steps:
<Master> mkdir test