H3C S5120-EI Series, Руководство по эксплуатации

Страница: 60 / 1191

1-9
Port type Reference
Stack ports
IRF Configuration
in the
System Volume
MAC address
authentication-enabled ports
MAC Authentication Configuration
in the
Security Volume
port security-enabled ports
Port Security Configuration
in the
Security Volume
IP source guard-enabled ports
IP Source Guard Configuration
in the
Security Volume
802.1X-enabled ports
802.1X Configuration
in the
Security Volume
Removing an aggregate interface also removes the corresponding aggregation group. At the same time,
all the member ports of the aggregation group, if any, leave the aggregation group.
Configuring a Static Aggregation Group
To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in the
same aggregation state.
Follow these steps to configure a static aggregation group:
To do... Use the command... Remarks
Enter system view
system-view
—
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Exit to system view
quit
—
Enter Layer 2 Ethernet
interface view
interface interface-type
interface-number
Assign the Ethernet interface to
the aggregation group
port link-aggregation group
number
Required
Repeat these two steps to
assign multiple Layer 2
Ethernet interfaces to the
aggregation group.
Configuring a Dynamic Aggregation Group