Guildline 6530 Series, Руководство оператора

Страница: 22 / 158

Section 2
OM6530-C1-00
19 November, 2019
2-4
2.4.1. SWITCH FUNCTIONS
2.4.1.1.Rear Panel POWER Entry
The on/off toggle switch is the only function that cannot be controlled by the
GPIB and RS-232C bus interfaces.
2.4.1.2.Front Panel KEYPAD
The keypad consists of a 3 key by 5 key momentary switch arrangement that
allows entry of a numeric sequence (0, 1, 2, 3, 4, 5, 6, 7, 8, 9). Additional keys in
the keypad layout allow for the selection of decimal point “.”, minus “-“,
“CLEAR”, exponent “E” and “LOAD” functions.
2.4.1.3. Front Panel Menu Navigation Keys
Two momentary action keys labeled “PREVIOUS” and “CANCEL” allow the
operator to move between menu levels of the 6530.
2.4.1.4.Front Panel Programmable Function Keys
This series of four momentary action keys allow for the selection of any one of 4
software-controlled actions. The action available for each function key is
displayed in the display directly above the key.
2.4.2. DISPLAY
The main display is a 256 by 64 dot vacuum-fluorescent graphic display that shows the
measured data and provides system level information to the operator during the
measurement cycle(s), as well as the software calibration and system initialization
procedures.
2.4.3. CONNECTORS
Two connectors are mounted to the front panel for attachment of the resistance or current
under test (see Figure 2-3 6530 Front Panel Terminals). The connectors are labeled
“SOURCE” and “INPUT”.
Figure 2-3: 6530 Front Panel Connectors