GUILCOR AR004926, Инструкция по эксплуатации, Страница: 54 / 75

54
Technical parameters
Power supply
The Multilogger is powered from batteries located under the removable
cover on the rear side of the device. An external power supply source can
be also connected to the Multilogger. When the device is connected to an
external power supply, the batteries are not used. If you want the Ethernet
interface to work, this external power supply voltage has to be connected.
However, some limited functions of this interface may be available for
battery operation (see
Device configuration : General - Advanced
–
Peripherals - Ethernet in battery mode options). Batteries can be recharged
in the device.
Batteries _______________________________________
Recommended battery type:
3x AA NiMH rechargeable batteries Sanyo ENELOOP
1,900 mAh, 1.2 V
Alternative batteries:
3 x AA alkaline battery 1.5 V
________________________________________________________________________________________________
When alkaline batteries are used, it is necessary to disable the
charger in the device configuration, i.e. to set the Multilogger for
Alkaline batteries.
Operating time of fully charged NiMH batteries:
> 1 month in the standard measuring mode
approximately 6 month in the power saving measuring
mode
________________________________________________________________________________________________
Applies to Multilogger without CO
2
, with fully charged batteries
of the recommended type; when the display backlight, LED
indication and audio signalization are turned off.
> 3 weeks in the standard measuring mode
approximately 3 month in the power saving measuring
mode
________________________________________________________________________________________________
Applies to Multilogger with CO
2
with fully charged batteries of
the recommended type; when the display backlight, LED
indication and audio signalization are turned off.
Current consumption when the Multilogger is turned off:
< 15 uA