GUILCOR AR004926, Инструкция по эксплуатации, Страница: 42 / 75

42
Ethernet - Email - General _________________________
Here you can do the basic email setup. If you want to use the sending
of warning emails on alarms, switch this function on (
Email sending
ON ). Next, set the IP address or SMTP server or its domain name
( SMTP Server ), port ( SMTP Server port ) and, if the server requires
authentication, enter your login name and password ( Autentication ).
Continue by entering addresses of up to three recipients of the
warning emails (
Email recipient #1 - #3 ) and, finally, enter the
address of the email sender ( Sender ). This is usually the same as the
user name in the SMTP authentication.
Ethernet - Email - Preferences _____________________
Here you can set further email parameters. If you want the
Multilogger to send the regular emails during the active alarm, enter
of their interval (
Repeat alarm sending interval). If you enter 0, the
email is sent only upon the start activity of alarm and upon end its
activity. Moreover, you can set sending of a regular informative email,
which informs the user that the Multilogger is working properly (
Keep
alive email sending ).
You can use shortened emails ( Short email ) especially for forwarding
them as SMS messages to mobile phones. You can also insert your
own comments to the emails: if the alarm appears (
Alarm note ), if the
alarm expires ( Clear alarm note ), in the case of system alarm
( System alarm note ) and in the case of exceeding the memory
occupation limit ( Memory overflow note ).
Ethernet - Datalink _______________________________
The Datalink protocol is used for connecting the Multilogger with
the database system. Connection to the server is opened by the
Multilogger in regular intervals. Further control of the communication
is then performed by the server. If you want to use this function, you
have to allow it (
Datalink On ). Next, enter the IP address or Datalink
server or its domain name ( Datalink address ), communication port
number ( Datalink port , default is 10002), connection opening interval
( Datalink interval ) and the database key ( Datalink key ). If you require
to send the irregular alarm messages using this protocol, you need to
allow asynchronous transmissions (
Asynchronous communication ).
Moreover, you can also set here the data downloading interval and
possibility of erasing recorded data in device.