GUILCOR AR004926, Инструкция по эксплуатации, Страница: 32 / 75

32
Connecting with the computer
You can connect the Multilogger to the computer through the following
communication interfaces:
•
USB - fast connection for short distances (up to 5 m, communication
speed of 460,800 Bd). Connect the device to the computer using the
supplied cable, launch the SW and add Multilogger to the list of your
devices.
•
RS232 - slow connection for distances of up to 15 m, designated mainly
for communication via GPRS modems (communication speed of
115,200 Bd / 230,400 Bd).
•
Ethernet - fast connection for long distances. An external power supply
source has to be connected to the Multilogger (for example, a power
supply adapter). The device IP address is preset to 192.168.1.78, the
default sub-net mask is used as well as port 10001 (we recommend not
changing the port number if it is not necessary).
Configuration:
a)
Verify if you can use the preset IP address with your
network administrator. If not, obtain a new IP address,
network mask, gateway address and address of the DNS
server from him/her.
b)
Set these parameters on the Multilogger (Menu - Device
settings - Ethernet interface) . Alternatively, you can
connect the Multilogger via USB interface and do the
above stated configuration using the
Vision
software.
c)
Connect the Multilogger into your LAN (Ethernet cable is
not included as device accessory).
d)
Launch the Vision software and add the
Multilogger to the list of your devices.
The Multilogger automatically identifies which communication interface is
connected and will use it for communication. When multiple interfaces are
connected, USB has the highest priority and Ethernet the lowest.
For
example, if Multilogger has to work over Ethernet, no USB or RS232
interface can be connected to the device.
ATTENTION - we recommend using the supplied power
adapter for battery charging. When you use a USB charger, the
Multilogger may not communicate when the charger is
connected!