Grizzly G0634Z insert, Руководство пользователя

Страница: 70 / 92

-56-
Model G0634Z/G0634XP (Mfd. Since 01/20)
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Items Needed Qty
Straightedge ...................................................... 1
Phillips Screwdriver ........................................... 1
To calibrate the depth scale:
1.
DISCONNECT MACHINE FROM POWER!
2.
Set the outfeed table height as described in
Setting Outfeed Table Height
on
Page 24
.
3.
Use the straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in
Figure 80
.
4.
Using a screwdriver, adjust the scale pointer
to zero (see
Figure 81
).
Figure 80.
Infeed table even with outfeed table.
Straightedge
Infeed Outfeed
Figure 81.
Depth scale adjusted to “0” position.
Depth Scale
Pointer
Depth Scale
Calibrating Depth
Scale
Setting Fence Stops
(G0634Z)
The fence stops simplify the task of adjusting the
fence to 45˚ and 90˚.
Items Needed Qty
45° Square......................................................... 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
To set the 90˚ fence stop:
1.
Loosen the lock nut on the 90° fence stop bolt
shown in
Figure 82
, and loosen the fence tilt
lock.
2.
Place a 90° square against the table and
fence, and adjust the stop bolt, so the fence
is set exactly at 90°.
3.
Tighten the lock nut.
4.
Adjust the indicator (if necessary) to 0° to
calibrate the fence tilt scale.
Figure 82.
Adjusting fence to 90˚.
Lock Nut
90˚Stop Bolt