Grizzly G0634Z insert, Руководство пользователя

Страница: 46 / 92

-32-
Model G0634Z/G0634XP (Mfd. Since 01/20)
Setting Jointer
Depth of Cut
Jointer Depth-of-Cut Scale
The depth of cut can be referenced directly from
the depth scale located on the front of the jointer,
as shown.
Note: The depth scale can be calibrated or
"zeroed" if it is not correct. Refer to
Calibrating
Depth Scale for more information.
The depth of cut on a jointer is the amount of
material removed from the bottom of the work-
piece as it passes over the cutterhead.
The depth of cut is set by adjusting the height of
the infeed table relative to the carbide inserts at
TDC (top dead center).
The jointer depth-of-cut scale (see
Figure 32
on
this page) goes up to
3
⁄
16
", however the recom-
mended depth of cut per pass is
1
⁄
16
"–
1
⁄
8
" depend-
ing on the operation.
DO NOT exceed the recommended depth of
cut per pass, or kickback and serious injury
may occur.
Adjusting Infeed Table Height
To adjust the infeed table height, use a 6mm hex
wrench to loosen the infeed table height lock,
rotate the infeed table height adjustment knob,
then tighten the table height lock to secure the
setting (see
Figure 32
).
— Rotate the infeed table height adjustment
knob
clockwise
to
raise
the table.
— Rotate the knob
counterclockwise
to
lower
the table.
Items Needed Qty
Hex Wrench 6mm .............................................. 1
Figure 32.
Location of jointer depth-of-cut scale
and infeed table height adjustment controls.
Jointer
Depth-of-Cut
Scale
Infeed Table
Height Lock
Infeed Table Height
Adjustment Knob
Figure 33.
Location of jointer depth-of-cut scale.
Depth Scale
Pointer
Depth Scale