Overhead Ceiling Fans
30
®
Refer
ence
Tr
oubleshooting
Oper
ation And
Maintenance
Fan
Netw
orking
Electrical
Installation
Fir
e System
Integr
ation
Mechanical Installation
Pr
e-Installation
Gener
al
Information
Quick Start
Guide
Motor Cable Connection
1. Using a phillips screwdriver, remove the black
plastic cover on the front side of the VFD and set
aside.
2. Locate the motor power, motor ground, and hall
sensor cables that protrude from the top side
of the motor. These cables should have been
routed to the front of the VFD during mechanical
installation.
3. Plug the motor power, motor ground, and hall
sensor cables into the VFD circuit board as shown
below. The motor power and hall sensor cables are
designed to only fit in one orientation. Use the wire
color references below and photos on the next two
pages to identify the proper orientation. Do not
force these plugs.
IMPORTANT:
The motor power, motor ground, and hall
sensor cables are not long enough to reach the VFD
circuit board from the rear side. If the cables are not
properly routed to the front of the VFD, the motor must
be uninstalled and rotated 180° so that the cables can
be connected.
Electrical Installation
HALL CABLE COLOR
PINOUT REFERENCE
HALL CONNECTION
NOTE:
HALL CABLE PLUG
HAS BUILT-IN ALIGNMENT TAB
DO NOT FORCE THIS PLUG
MOTOR GROUND
MOTOR POWER