Overhead Ceiling Fans
24
®
Gripple
®
Hardware (Optional)
Components required from Bag # 915067:
• No. 4 Gripple
®
Connector (1)
Hardware/Tools (Not Included):
• 1/16 in. Allen Wrench (optional)
• Cable Cutters (optional)
1. From the top of the downtube, pull the safety
retention cable until the cable is taut inside the
downtube.
2. Insert the loose end of the safety cable into the No.
4 Gripple connector. Note that the cable will only
feed through the Gripple connector in one direction
(marked on the Gripple connector with an arrow).
3. Slide the No. 4 Gripple connector down the safety
cable until it is located near the opening at the top
of the downtube.
4. Wrap the loose end of the safety cable around
the mounting structure. Do not allow the cable to
come in contact with any sharp edges.
5. Insert the loose end of the safety cable into the
open hole of the No. 4 Gripple connector. Note
that the cable will only feed through the Gripple
connector in one direction (marked on the Gripple
connector with an arrow).
6. Pull the loose end of the safety cable through the
Gripple connector to tighten the cable. The cable
should be pulled taut, leaving only a small amount
of slack in the cable to ensure proper functioning.
7. Cut or organize excess safety cable to ensure it
does not interfere with fan rotation.
NOTE:
If necessary, the safety cable can be loosened
by inserting the long end of a 1/16 in. allen wrench into
either of the pin holes on the No. 4 Gripple connector
and pulling the cable in the opposite direction of the
arrow marked on the Gripple connector.
DOWNTUBE SAFETY CABLE
DOWNTUBE SAFETY CABLE
DOWNTUBE & MOUNT ASSEMBLY
NO. 4 GRIPPLE
Refer
ence
Tr
oubleshooting
Oper
ation And
Maintenance
Fan
Netw
orking
Electrical
Installation
Fir
e System
Integr
ation
Mechanical Installation
Pr
e-Installation
Gener
al
Information
Quick Start
Guide
