GRASS VALLEY XIP-3901, Руководство пользователя

Страница: 220 / 308

220
Configuring the XIP - 3901 - GB - IP Application with iControl
GB1 / GB2 Tabs
Property Description
Operation
Mode
Quad Stream UHD 2SI Division:
Sends 4

3G 2SI division 1080p IP output signals.
Quad Stream UHD Square Division: Sends 4

3G square division 1080p IP output signals.
Single Stream UHD: Sends 1

12G single-stream 2160p IP output signal.
Audio
Type:
Use the pull-down to set the audio stream’s type for streams
Audio 1
to
Audio 4
.
•
Type SMPTE ST 2110-30
: for PCM linear audio (AES67 compatible)
• Type SMPTE ST 2110-31 : for transparent transport of non-linear audio and data formats.
Provides bit-transparent AES3 over IP.
Profile : Use the pull-down to set audio profile for streams Audio 1 to Audio 4 . Audio senders
support Level C as per SMPTE 2110-30/31: 48kHz stream from 1 to 8 channels (1 to 4 for
SMPTE 2110-31) at packet times of 1ms and 1 to 64 channels (1 to 60 for SMPTE 2110-31) at
packet time of 125us.
For
Audio 2 to Audio 4 , only the first 16 channels will carry active audio and channels 17-64
will carry silence.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
Master Set to enable a media sender. This manages both the primary and secondary streams. This
can also be managed by external NMOS control. See NMOS Panel , on page 213.
Media Shows the stream type.
RTP Stream Set to enable a media stream sender for primary and secondary. This can also be managed
by external NMOS control. See NMOS Panel , on page 213.
Stream Shows the primary (ETH1) and secondary (ETH2) streaming status:
Green: streaming
Red: not streaming
Grey: not active
When the Operation Mode is Quad Stream UHD 2SI Division or Quad Stream UHD Square
Division, the streams for Video 1 to Video 4 should be green.
When the
Operation Mode
is
Single Stream UHD
, the streams for
Video 1
should be green
and the streams for Video 2 to Video 4 should be grey.
TX Stream
Address
Set the IP address and UDP port number of the outgoing stream. IP address 0.0.0.0 disables a
sender. The default UDP port values are 10000.
Address & UDP port can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
TX Stream
Port
SDP File
Click to show the last SDP file transmitted through NMOS since the last bootup. This window
does not refresh automatically; you need to close and re-open the window to see an update.
If the card has never received an SDP file since its last bootup, the window will be empty.
Apply
Cancel When active, this applies or rejects your current changes made in this tab except for Audio
Type and Audio Profile