GRASS VALLEY XIP-3901, Руководство пользователя

Страница: 216 / 308

216
Configuring the XIP - 3901 - GB - IP Application with iControl
Config Tab
Audio
Type:
Use the pull-down to set the audio source stream’s type for streams
Audio 1
to
Audio 4 .
•
Type SMPTE ST 2110-30
: for PCM linear audio (AES67 compatible)
• Type SMPTE ST 2110-31 : for transparent transport of non-linear audio and data
formats: provides bit-transparent AES3 over IP
Profile: Use the pull-down to set the audio profile for streams Audio 1 to Audio 4 . Audio
receivers support Level C as per SMPTE 2110-30/31: 48kHz stream from 1 to 8 channels (1
to 4 for SMPTE 2110-31) at packet times of 1ms and 1 to 64 channels (1 to 60 for SMPTE
2110-31) at packet time of 125us.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
Master Set to enable a media receiver. This manages the Join/Release of both the primary and
secondary streams.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
Media Shows the stream type. The background shows the current media status:
Green:
no error
Red: error
Grey: inactive
When the Operation Mode is Quad Stream UHD 2SI Division or Quad Stream UHD Square
Division, Video 1 to Video 4 should be green.
When the
Operation Mode is Single Stream UHD , Video 1 should be green and Video 2
to Video 4 should be grey.
RTP Stream Set to enable each stream receiver individually (primary and secondary).
Stream Shows the primary (ETH1) and secondary (ETH2) stream receiver status:
Green: no error
Red: error
Grey: inactive
IGMPv3 Source Set the source from which to receive multicast streams. With this protocol, the card deals
with a switch to subscribe to one or many streams that are coming from different sources.
Both iGMPv3 and iGMPv2 protocols are supported. Set this to 0.0.0.0 if iGMP source is not
used. The source range is 0.0.0.0 to 255.255.255.255. The default value is 0.0.0.0.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
RX Stream
Address
Set the IP address and UDP port number at which this card receives a specific stream. IP
address 0.0.0.0 disables a receiver. The default UDP port values are: 10000 for all media
receivers.
These settings can also be managed by external NMOS control. See
NMOS Panel , on
page 213.
RX Stream Port
Property Description