GRASS VALLEY XIP-3901, Руководство пользователя

Страница: 111 / 308

111
XIP - 3901
User Manual
Control Port
ETH3,
Control Port
Frame (FRM)
The FRM port is a bridged port through the Densité frame controller. The physical frame
controller's Ethernet port must be connected to the network for this interface to work. See
Connections and Cabling , on page 53. Note: The FRM port address must not contain any of
the frame controller's IP addresses.
Control ports can be used for firmware upgrades:
• If the card is installed in a Densité 3+FR1 or Densité 3+FR4 frame with a CPU-ETH3 Basic
controller, the ETH3 port must be used. Note: Before upgrading through the ETH3 port,
you will need to configure ETH3 through local menu or install the iControl bundle for
the current firmware version in order to configure ETH3. Once ETH3 has been
configured, you will be able to upgrade/downgrade the card and its iControl bundle.
• If the card is installed in a Densité 3+FR4 frame with a CPU-ETH3 Standard or Advanced
controller, the firmware upgrade is performed using the frame controller’s Ethernet port
(FRM).
Mode Set the mode to assign an IP address to an Ethernet port.
Off:
Ethernet port disabled, it will not be used.
Auto (DHCP): Ethernet port enabled with automatic configuration using a network's DHCP
server.
Static: Ethernet port enabled with static user specified configuration ( IP Address , Subnet
Mask
, and
Gateway
).
IP Address When Mode is set to Static , set the card’s IP address.
Subnet Mask When Mode is set to Static , set the subnet mask for your network.
Gateway When
Mode
is set to
Static
, set the network switch’s IP address.
MAC address Shows the Ethernet port’s MAC Address.
LLDP
Shows the Link Layer Discovery Protocol (LLDP) TLV values. LLDP is used to advertise the
identity, capabilities, and neighbors on a LAN. Click
Details
for any one Ethernet port to view
the LLDP TLV values. See Network ETH LLDP Properties , on page 112.
Test Address Test the IP connectivity to a device (on the same network) from any one Ethernet port for
troubleshooting purposes. Enter the device’s IP address and click
Ping
. In
Status
, a message
shows the ping’s IP connectivity status.
Apply
Cancel When active, this applies or rejects your current changes. Pending changes are displayed in
red.
Property Description