2
Tap [Menu], and then tap [Tools] -> [T2 to T2 Sync backup...].
If contents are being captured or loaded in the R1/P1/P2 channel, a message
appears asking whether to unload the contents. Tap [OK] to unload the clip.
3
In [Operating mode] on the [T2 to T2 Sync backup] dialog box,
select [Slave mode] and tap [Close].
T2 on the sync destination (slave) is set to the slave mode.
To sync data to multiple T2 (slave), repeat steps 1 to 3 on all of the T2 (slave).
Step 2: Setting T2 on the sync source to the master
mode for data sync
1
On the sync source T2, tap [Bin] or [1ch View].
2
Tap [Menu], and then tap [Tools] -> [T2 to T2 Sync backup...].
If contents are being captured or loaded in the R1/P1/P2 channel, a message
appears asking whether to unload the contents. Tap [OK] to unload the clip.
3
In [Operating mode] on the [T2 to T2 Sync backup] dialog box,
select [Master mode] and tap [Slave configuration...].
T2 on the sync source (master) is set to the master mode.
The number of T2 set to the slave mode is displayed in [Slave count:].
4
In the [Slave configuration...] dialog box, set the IP address of T2
set to the slave mode.
•
Tap [Auto Search...] to search for T2 set to the slave mode on the
network. Select an IP address on the [Search Results] dialog box, and
then tap [Add ALL].
•
To set an IP address manually, tap [Add] and enter an IP address.
5
Tap [Close].
6
In the [T2 to T2 Sync backup] dialog box, tap [Start Sync].
7
A message appears. Tap [OK].
The synchronization starts. You can check the file transfer status on the
upper progress bar, and the whole status on the lower progress bar.
91
May 16, 2016
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express User Manual
Backing up all data to other T2 (full sync backup)
