Controlling T2 with TC Chase (P1/P2-remote mode)
This section describes the settings for TC Chase control to perform
playback where the LTC input to the R1 channel and the timecode of P1/
P2 channel are synchronized.
TC Chase control requires reference signal and video signal input that
synchronizes with the input LTC, in addition to the LTC input to the R1 channel.
TIP
•
For detailed procedures for TC Chase, refer to a separate
document released on our website.
1
Tap [Config.] on the touch screen LCD of T2.
2
Tap [General], and then tap the [Hardware] tab.
3
Select a [External] from the list of [Reference :].
Confirm that it is synchronized with the input reference signal correctly.
4
Tap [R1], and then tap the [Input Settings] tab.
5
Select [Input type :] and [Input format :] used for the input video signal.
6
Tap [P1] or [P2], and then tap the [Video] tab.
7
Select the format to playback.
8
Tap the [Monitor & Remote] tab.
P1/P2 – Monitor & Remote settings
9
Select a [TC Chase] from the list of [Remote protocol:].
TIP
•
Check [Enable local operations while being remote controlled.]
to operate T2 locally even in the remote mode.
P1/P2 – Monitor & Remote settings
10
Tap [OK].
11
Press the [P1] button.
12
Tap [Menu], and then tap [Remote].
[Remote] will be checked.
P1/P2 channel will be played back, being synchronized with the LTC
input to the R1 channel.
242
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express User Manual
May 16, 2016
Section 11 ― Remote Control
