GRASS VALLEY IQUCP25, Руководство пользователя

Страница: 28 / 338

28
UCP - 3901 Card Installation and Operation
Front Card-edge Interface
Item Description
Ident Button Push to:
• Make the card’s SDI IN LEDs flash.
• Activate the
Configuration
>
Location
>
Where Am I
checkbox in
RollCall.
This works bi-directionally between the card and the RollCall setting.
See also Configuration , on page 75 for more information about the
Where Am I checkbox.
Ejector Tab Lift the bottom edge of the ejector tab to lever and remove the card
out of the frame. See Installation of the Rear Connector Panel and
Card , on page 31.
SDI IN 1 to SDI IN
16 status LEDs
As an input, this shows the following port status:
• Green: Signal is detected.
•
Yellow:
Test pattern generator has been activated.
• Red: Signal loss.
• Off: Input/Spigot not in use.
As an output, this shows the following port status:
•
Green:
Valid flow is detected.
• Yellow: Test pattern generator has been activated.
• Red: Flow is not found or invalid.
• Off: Output/Spigot not in use.
See also Spigot Pages , on page 121 and Logging - SDI Info , on
page 138 for more information.
For UHD Quad-Link Modes:
Banks of four adjacent LEDs (for example, 1 - 4, 5 - 8, and so on) will
light simultaneously to denote the 4 x 3G streams being received on a
12G-SDI input. If a TPG is enabled, either sender or receiver, four
adjacent LEDs will become yellow to denote the 4 x 3G linked internal
flows. See Sender TPG (Test Pattern Generator) , on page 91 or
Receiver TPG (Test Pattern Generator) , on page 92, when applicable to
the SDC.
SFP 1 to SFP 4
status LEDs
Shows the SFP 1, 2, 3, and 4 link status:
• Blue: Link OK (25G/50G/100G SFP).
•
Blue flashing:
SFP detected, link down (fiber not connected,
different FEC selection from host).
•
Unlit:
SFP not detected.
See also Ethernet Pages 1 and 2 , on page 101 and Logging - Network ,
on page 145 for more information.