GRASS VALLEY IQUCP25, Руководство пользователя

Страница: 178 / 338

178
MADI Processing SDC
Time Sync Configuration
Time Sync Configuration
The Time Sync Configuration page allows selection of the source to be used for
synchronizing flows, and configuration of any properties associated with the relevant
source. To use PTP, first set
Genlock
to
Network
. See Configuration on page 174.
Figure 7 - 3: Time Sync Configuration Page
Parameter Description
Time Sync Mode Click a radio button to select the required mode. Note that the PTP
options require a grandmaster clock to be present in the system.
NTP Configuration To add an NTP server, enter the server’s IP address into the
New
field.
PTP Network
Interface
Set the check boxes to enable the network interfaces on which PTP is
supported. Enable check boxes as required.
Ethernet 1: represents the rear panel SFP1 connection.
Ethernet 2: represents the rear panel SFP2 connection.
See Connections and Cabling on page 53 for connector
information.
The
Preference
pulldown sets the primary interface to use. If the
primary interface fails, the alternate interface (if enabled) will be
switched to automatically.
None: PTP will fail over from one to the next in the absence of sync
messages. Once failed over, it shall remain on that port until it fails
over again.
Ethernet 1: If Ethernet 1 is available, it has priority. Thus, if there is a
failover from Ethernet 1 to Ethernet 2, as soon as Ethernet 1 becomes
available again, it will switch back to Ethernet 1.
Ethernet 2:
as per Ethernet 1 but for Ethernet 2.