Administrator
69
4
Motion Detection Setting
Users could adjust various parameters of Motion Detection in this section.
•
Sampling pixel interval [1-10]:
The default value is 1, which means system will take one sampling pixel for every pixel.
•
Detection level [1-100]:
The default level is 10. The item is to set detection level for each sampling pixel; the
smaller the value, the more sensitive for each sampling pixel.
•
Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are detected
differently, system will detect motion. The bigger the value, the more sensitive it is.
Meanwhile, when the value is bigger, the red horizontal line in the motion indication
window will be lower accordingly.
•
Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each detected motion.
Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion is detected. All
options are listed as follows:
•
Enable Alarm Output 1/2
Check the item and select the predefined type of alarm output to enable alarm relay
output when motion is detected.
•
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or E-Mail
when motion is detected.
•
Upload Image by FTP
Select this item and the Administrator can assign a FTP site and configure various
parameters. When motion is detected, event images will be uploaded to the appointed
FTP site.
•
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure
various parameters. When motion is detected, event images will be sent to the
appointed e-mail address.